How to Replace a Front Door Casing

How to Replace a Front Door Casing

Casing, which is may be a decorative layout or square or rounded molding. If you would like to replace casing, or if you merely want a new look for your door, you can certainly do it yourself with a carpentry tools. Exterior casing ought to be treated to protect it from elements, to ensure it is durable and durable.

Place the flat end of a pry bar in the part of the casing in the places. Reach the back of the pry bar with a hammer to wedge the flat end underneath the casing.

Pry the shell out of the outside wall. Continue prying the casing working every few inches up. Place a small piece of wood between the siding as well as the pry bar to prevent damage to the siding as you remove the casing.

Remove in the outside wall by means of a pry bar feature along with a hammer claw. Scrape away any caulking which might have been utilized to seal the casing edges.

Transfer the old casing measurements by tracing the measurements of the bit that is old to the lumber or by using a tape measure. Cut on the layout lines armed with a finish blade.

Place the casing to the doorway to ensure the length and cuts are correct. Pull down the casing bit and set it on a work surface that is flat.

A drill with a bit that’s slightly smaller than the 8-or 10-penny brad nails. Drill pilot holes 3 inches from every 12 inches and the bottom and top edges in between at the center of the lumber.

Hold the casing to the doorway and hammer on 8-or 10-penny nails to secure the piece. Move on to another bit of casing until the right, left and head casing is substituted using the installation procedure. Sink the brad nail head below the casing confront by means of a nail set and also a hammer.

Cut 1/4 apply a bead around the edges and the ends of the casing and then inch from the tip of a tube. Spread the caulk evenly to the corners together with a tool or your finger to close up any seams that may allow water to float in. Place a little bit of caulking on the tip of your finger and then cover each nail head to finish the casing installation.

See related