The best way to Know When There Is Electrical Behind a Wall When Hanging Shelves

Hanging shelves through wood paneling or dry wall looks simple enough. Drill a hole, insert a screw anchor if heading going right through dry wall, and screw-in a shelf bracket. But it is vital to to know what’s behind the wall you’re drilling into. There could be electrical wires on the other side of the wall that the drill can touch , that could be severed, or worse, give an awful shock to you. Find out in which the wiring is.

Place the studfinder with wire tracing mode on the wall. These are available at home and hardware stores and garden retailers. Flip the switch on the studfinder to “AC” mode.

Move front closer, the finder over the wall as well as the flat side from the wall. Some will have a little meter that can begin as the studfinder gets near showing voltage, the others will have lights that start to illuminate.

Move the studfinder on the wires. In the event that you’re in the vicinity of stove wires on finders, when they can be exactly on the wire, the meter will study 120-volts, or 22. When the studfinder is immediately on the wire, a stud-finder that utilizes a mild band will display most of the lights getting illuminated. One of the lights will go out, in the event that you shift somewhat to the left or right of the wire.

Mark the location of the of the identified wire using a marker, then use that mark as a reference when drilling for shelf installation holes to a void that location.