The best way to Put a Plate Groove in a Shelf
Shelves allow you show collections of pottery, china and other serveware decoratively, as well as the groove over the shelf retains the plates relatively secure. For those who have a great wood shelf that doesnât have a groove for plates, it is possible to add one relatively basically. The groove in a plate shelf is an area that’s far enough from the back fringe of of the shelf to keep the plates up right without allowing them to topple ahead . in around 1/4 to 1/2 inch-wide and located in This place can differ depending how large or small the plates are.
Choose the area. Very deep or big plates might require a groove that’s farther in the wall than plates that are smaller. Most of the time, a groove that’s between 1 and 1 1/2 inches from the back fringe of of the shelf is flexible enough to help several different plate dimensions.
Measure in the back fringe of of the shelf to the the location you mark the shelf at that place using a pencil and have chosen for the groove.
Set the fence on a router to the measurement which you took for the plate groove area. Set the fence in the event that you are using a router table.
Set the straight- router bit into a depth that was cutting which is the thickness of the shelf.
Place the shelf face-up on a work table with all the edge of the shelf somewhat past the edge of the dining table. The shelf to the dining table with spring loaded wood clamps or c clamps. Omit this, in the event that you are using a router table.
Put on goggles or safety glasses and start the router.
Place a router that is handheld at the conclusion of the shelf with all the fence of the router butted from the edge of the shelf where it overhangs the dining table. In the event that you are using a router table, spot the shelf face-down together with the again edge of the shelf butted contrary to the fence on the finish of the table, and prepare to drive the shelf to the router bit.
Push the router over the shelf, retaining the fence comfortable contrary to the edge of the shelf and reducing the groove over the shelf from end-to-end. Push the shelf on the other side of the table, in the event that you are using a router dining table and to the bit, maintaining the again edge comfortable contrary to the fence. As you close to the end-of the shelf, use ablock of wood to end pushing the shelf on the other side of the router bit.
Turn the router off and eliminate the shelf.
Sand the groove with -good-grit sandpaper, if essential, to eliminate tough edges.
Brush a mild coat of paint or urethane within the groove.